|
BINAC, the Binary Automatic Computer, was an early electronic computer designed for Northrop Aircraft Company by the Eckert-Mauchly Computer Corporation in 1949. Eckert and Mauchly, though they had started the design of EDVAC at the University of Pennsylvania, chose to leave and start Eckert–Mauchly Computer Corporation (EMCC), the first computer company. BINAC was their first product, the first stored-program computer in the US, and the world's first commercial digital computer. ==Architecture== The BINAC was an advanced bit-serial binary computer with two independent CPUs, each with its own 512-word acoustic mercury delay line memory. The CPUs continuously compared results to check for errors caused by hardware failures. It used approximately 700 vacuum tubes. The 512-word acoustic mercury delay line memories were divided into 16 channels each holding 32 words of 31 bits, with an additional 11-bit space between words to allow for circuit delays in switching. The clock rate was 4.25 MHz (1 MHz according to one source) which yielded a word time of about 10 microseconds. The addition time was 800 microseconds and the multiplication time was 1200 microseconds. New programs or data had to be entered manually in octal using an eight-key keypad. BINAC was significant for being able to perform high-speed arithmetic on binary numbers, with no provisions to store characters or decimal digits. ==Customer acceptance== The BINAC ran a test program (consisting of 23 instructions) in March 1949, although it was not fully functional at the time. Here are early test programs that BINAC ran: * February 7, 1949 - Ran a five-line program to fill the memory from register A. * February 10, 1949 - Ran a five-line program to check memory. * February 16, 1949 - Ran a six-line program to fill memory. * March 7, 1949 - Ran 217 iterations of a 23-line program to compute squares. It was still running correctly when it stopped. * April 4, 1949 - Ran a fifty-line program to fill memory and check all instructions. It ran for 2.5 hours before encountering an error. Shortly after that it ran for 31.5 hours without error. Northrop accepted delivery of BINAC in September 1949. Northrop employees said that BINAC never worked properly after it was delivered, although it had worked at the Eckert-Mauchly workshop. It was able to run some small problems but did not work well enough to be used as a production machine. Northrop attributed the failures to it not being properly packed for shipping when Northrop picked it up; EMCC said that the problems were due to errors in re-assembly of the machine after shipping. (Northrop, citing security considerations, refused to allow EMCC technicians near the machine after shipping, instead hiring a newly graduated engineering student to re-assemble it. EMCC said that the fact that it worked at all after this was testimony to the engineering quality of the machine.) 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「BINAC」の詳細全文を読む スポンサード リンク
|