|
BWPing is a tool to measure bandwidth and response times between two hosts using Internet Control Message Protocol (ICMP) echo request/echo reply mechanism. It does not require any special software on the remote host. The only requirement is the ability to respond on ICMP echo request messages. BWPing supports both IPv4 and IPv6 networks. == Command syntax ==
Available options are: * -u - Sets the send/receive buffer size in bytes. Default value will be automatically calculated based on transfer speed, packet size and host timer accuracy. * -r - Sets the interval time in seconds between periodic bandwidth, RTT, and loss reports. If zero, there will be no periodic reports (default). * -T - Sets the TOS value of outgoing IPv4 packets or IPv6 Traffic Class value of outgoing IPv6 packets. Default value is zero. * -B - Sets the source address of outgoing ip packets. By default the address of the outgoing interface will be used. * -b - Sets the transfer speed in kilobits per second. * -s - Sets the packet size in bytes. * -v - Sets the volume to transfer in bytes. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「BWPing」の詳細全文を読む スポンサード リンク
|