|
In toxicology, the median lethal dose, LD50 (abbreviation for "lethal dose, 50%"), LC50 (lethal concentration, 50%) or LCt50 is a measure of the lethal dose of a toxin, radiation, or pathogen. The value of LD50 for a substance is the dose required to kill half the members of a tested population after a specified test duration. LD50 figures are frequently used as a general indicator of a substance's acute toxicity. A lower LD50 is indicative of increased toxicity. The test was created by J.W. Trevan in 1927.〔(What is an LD50 and LC50 )〕 The term semilethal dose is occasionally used with the same meaning, in particular in translations from non-English-language texts, but can also refer to a ''sub''lethal dose; because of this ambiguity, it is usually avoided. LD50 is usually determined by tests on animals such as laboratory mice. In 2011 the US Food and Drug Administration approved alternative methods to LD50 for testing the cosmetic drug BOTOX without animal tests.〔 〕〔 〕 == Conventions == The LD50 is usually expressed as the mass of substance administered per unit mass of test subject, typically as ''milligrams of substance'' per ''kilogram of body mass'', but stated as nanograms (suitable for botulinum), micrograms, milligrams, or grams (suitable for paracetamol) per kilogram. Stating it this way allows the relative toxicity of different substances to be compared, and normalizes for the variation in the size of the animals exposed (although toxicity does not always scale simply with body mass). The choice of 50% lethality as a benchmark avoids the potential for ambiguity of making measurements in the extremes and reduces the amount of testing required. However, this also means that LD50 is ''not'' the lethal dose for all subjects; some may be killed by much less, while others survive doses far higher than the LD50. Measures such as "LD1" and "LD99" (dosage required to kill 1% or 99%, respectively, of the test population) are occasionally used for specific purposes.〔(REGISTRY OF TOXIC EFFECTS OF CHEMICAL SUBSTANCES (RTECS) COMPREHENSIVE GUIDE TO THE RTECS )〕 Lethal dosage often varies depending on the method of administration; for instance, many substances are less toxic when administered orally than when intravenously administered. For this reason, LD50 figures are often qualified with the mode of administration, e.g., "LD50 i.v." The related quantities LD50/30 or LD50/60 are used to refer to a dose that without treatment will be lethal to 50% of the population within (respectively) 30 or 60 days. These measures are used more commonly within Radiation Health Physics, as survival beyond 60 days usually results in recovery. A comparable measurement is LCt50, which relates to lethal dosage from exposure, where C is concentration and t is time. It is often expressed in terms of mg-min/m3. LCt50 is the dose that will cause incapacitation rather than death. These measures are commonly used to indicate the comparative efficacy of chemical warfare agents, and dosages are typically qualified by rates of breathing (e.g., resting = 10 l/min) for inhalation, or degree of clothing for skin penetration. The concept of Ct was first proposed by Fritz Haber and is sometimes referred to as Haber's Law, which assumes that exposure to 1 minute of 100 mg/m3 is equivalent to 10 minutes of 10 mg/m3 (1 × 100 = 100, as does 10 × 10 = 100). Some chemicals, such as hydrogen cyanide, are rapidly detoxified by the human body, and do not follow Haber's Law. So, in these cases, the lethal concentration may be given simply as LC50 and qualified by a duration of exposure (e.g., 10 minutes). The Material Safety Data Sheets for toxic substances frequently use this form of the term even if the substance does follow Haber's Law. For disease-causing organisms, there is also a measure known as the median infective dose and dosage. The median infective dose (ID50) is the number of organisms received by a person or test animal qualified by the route of administration (e.g., 1,200 org/man per oral). Because of the difficulties in counting actual organisms in a dose, infective doses may be expressed in terms of biological assay, such as the number of LD50's to some test animal. In biological warfare infective dosage is the number of infective doses per minute for a cubic meter (e.g., ICt50 is 100 medium doses - min/m3). 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Median lethal dose」の詳細全文を読む スポンサード リンク
|