翻訳と辞書
Words near each other
・ Pluduno
・ Pludwiny
・ Pluerohoplites
・ Plufur
・ Plug
・ Plug & Pray
・ Plug (accounting)
・ Plug (comics)
・ Plug (fishing)
・ Plug (horticulture)
・ Plug (jewellery)
・ Plug (sanitation)
・ Plug 1 & Plug 2 Present... First Serve
・ Plug and feather
・ Plug and fight
Plug and play
・ Plug board
・ Plug compatible
・ Plug computer
・ Plug door
・ Plug flow
・ Plug flow reactor model
・ Plug In + Play
・ Plug In America
・ Plug In Baby
・ Plug in the Snakes
・ PLUG Independent Music Awards
・ Plug Ins
・ Plug It In
・ Plug It In (song)


Dictionary Lists
翻訳と辞書 辞書検索 [ 開発暫定版 ]
スポンサード リンク

Plug and play : ウィキペディア英語版
Plug and play

In computing, a plug and play device or computer bus, is one with a specification that facilitates the discovery of a hardware component in a system without the need for physical device configuration or user intervention in resolving resource conflicts.〔(The PC Guide - Plug and Play )〕〔(plug and play Definition )〕
Plug and play devices can be due to boot-time assignment of device resources and to hotplug systems such as USB and IEEE 1394 (FireWire).〔(Plug and Play Definition )〕
==History of device configuration==

In the beginnings of data processing technology, the hardware was just a collection of modules, and the functions of those modules had to be linked to accommodate different calculating operations. This linking was usually done by connecting some wires between modules and disconnecting others. For many mechanical data processing machines, such as the IBM punched card accounting machines, their calculating operations were directed by the use of a quick-swap control panel wired to route signals between module sockets.
As general purpose computing devices developed, these connections and disconnections were instead used to specify locations in the system address space where an expansion device should appear, in order for the device to be accessible by the central processing unit. If two or more of the same type of device were installed in one computer, it would be necessary to assign the second device to a separate, non-overlapping region of the system address space so that both could be accessible at the same time.
Some early microcomputing devices such as the Apple II sometimes required the end-user to physically cut some wires and solder others together to make configuration changes. The changes were intended to be largely permanent for the life of the hardware.
As computers became more accessible to the general public, the need developed for more frequent changes to be made by computer users unskilled with using soldering irons. Rather than cutting and soldering connections, configuration was accomplished by jumpers or DIP switches.
However, the process of configuring devices manually using jumpers or DIP switches could be quite difficult, and there was usually no forgiveness for technical inexperience. Incorrect settings could render either the whole system or just the expansion device completely or partially inoperable. Some settings such as for interrupts (IRQ) or direct memory access (DMA) required knowledge of what configuration had been previously manually assigned to other devices, as well as what settings the main system itself may be using. The system might still seem to work properly with an incorrect setting, until the IRQ or DMA is actually needed and the entire system suddenly freezes and must be reset.

抄文引用元・出典: フリー百科事典『 ウィキペディア(Wikipedia)
ウィキペディアで「Plug and play」の詳細全文を読む



スポンサード リンク
翻訳と辞書 : 翻訳のためのインターネットリソース

Copyright(C) kotoba.ne.jp 1997-2016. All Rights Reserved.