|
''Repoussé'' or ''repoussage'' (; respectively) is a metalworking technique in which a malleable metal is ornamented or shaped by hammering from the reverse side to create a design in low relief. There are few techniques that offer such diversity of expression while still being relatively economical. Chasing is the opposite technique to repoussé, and the two are used in conjunction to create a finished piece. It is also known as embossing. While ''repoussé'' is used to work on the reverse of the metal to form a raised design on the front, chasing is used to refine the design on the front of the work by sinking the metal. The term chasing is derived from the noun "chase", which refers to a groove, furrow, channel or indentation. The adjectival form is "chased work". The techniques of repoussé and chasing utilise the plasticity of metal, forming shapes by degrees. There is no loss of metal in the process, as it is stretched locally and the surface remains continuous. The process is relatively slow, but a maximum of form is achieved, with one continuous surface of sheet metal of essentially the same thickness. Direct contact of the tools used is usually visible in the result, a condition not always apparent in other techniques, where all evidence of the working method is eliminated. ==Etymology== The word ''repoussé'' is French and means "pushed up", ultimately from (ラテン語:pulsare), which means "to push". Repoussage is the noun to refer to the technique, with ''repoussé'' being an adjective referring to a piece to which the technique has been applied (e.g. "''repoussé'' work", "''repoussé'' piece"). Chasing comes from the French word, ''chasser'' meaning to drive out, or to chase around which is what the artists are doing as they "chase" the forms on their metal in order to create their final design. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Repoussé and chasing」の詳細全文を読む スポンサード リンク
|