|
iCub is a 1 metre high humanoid robot testbed for research into human cognition and artificial intelligence. It was designed by the RobotCub Consortium of several European universities and built by Italian Institute of Technology, and is now supported by other projects such as ITALK.〔(【引用サイトリンク】 An open source cognitive humanoid robotic platform )〕 The robot is open-source, with the hardware design, software and documentation all released under the GPL license. The name is a partial acronym, ''cub'' standing for Cognitive Universal Body. Initial funding for the project was €8.5 million from (Unit E5 ) – Cognitive Systems and Robotics – of the European Commission's Seventh Framework Programme, and this ran for sixtyfive months from 1 September 2004 until 31 January 2010. The motivation behind the strongly humanoid design is the embodied cognition hypothesis, that human-like manipulation plays a vital role in the development of human cognition. A baby learns many cognitive skills by interacting with its environment and other humans using its limbs and senses, and consequently its internal model of the world is largely determined by the form of the human body. The robot was designed to test this hypothesis by allowing cognitive learning scenarios to be acted out by an accurate reproduction of the perceptual system and articulation of a small child so that it could interact with the world in the same way that such a child does.〔 == Specifications == The dimensions of the iCub are similar to that of a 2.5 year old child. The robot is controlled by an on-board PC104 controller which communicates with actuators and sensors using CANBus. It utilises tendon driven joints for the hand and shoulder, with the fingers flexed by teflon-coated cable tendons running inside teflon-coated tubes, and pulling against spring returns. Joint angles are measured using custom-designed Hall-effect sensors and the robot can be equipped with torque sensors. The finger tips can be equipped with tactile touch sensors, and a distributed capacitive sensor skin is being developed. The software library is largely written in C++ and uses YARP for external communication via Gigabit Ethernet with off-board software implementing higher level functionality, the development of which has been taken over by the RobotCub Consortium. The robot was not designed for autonomous operation, and is consequently not equipped with onboard batteries or processors required for this —instead an umbilical cable provides power and a network connection.〔 In its final version, the robot has 53 actuated degrees of freedom organized as follows: * 7 in each arm * 9 in each hand (3 for the thumb, 2 for the index, 2 for the middle finger, 1 for the coupled ring and little finger, 1 for the adduction/abduction) * 6 in the head (3 for the neck and 3 for the cameras) * 3 in the torso/waist * 6 in each leg The head has stereo cameras in a swivel mounting where eyes would be located on a human and microphones on the side. It also has lines of red LEDs representing mouth and eyebrows mounted behind the face panel for making facial expressions. Since the first robots were constructed the design has undergone several revisions and improvements, for example smaller and more dexterous hands, and lighter, more robust legs with greater joint angles and which permit walking rather than just crawling. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「ICub」の詳細全文を読む スポンサード リンク
|