pseudorapidity について

and the positive direction of the beam axis.〔Introduction to High-Energy Heavy-Ion Collisions, by Cheuk-Yin Wong, See page 24 for definition of rapidity.〕 Inversely,
:

\theta = 2\arctan\left(e^\right).

As a function of three-momentum

\mathbf

, pseudorapidity can be written as
:

\eta = \frac \ln \left(\frac}}\right) = \operatorname\left(\frac\right),

where

p_\text

is the component of the momentum along the beam axis (i.e. the ''longitudinal'' momentum – using the conventional system of coordinates for hadron collider physics, this is also commonly denoted

p_z

). In the limit where the particle is travelling close to the speed of light, or equivalently in the approximation that the mass of the particle is negligible, one can make the substitution

m \ll p \Rightarrow E \approx p \Rightarrow \eta \approx y

(i.e. in this limit, the particle's only energy is its momentum-energy, similar to the case of the photon), and hence the pseudorapidity converges to the definition of rapidity used in experimental particle physics:
:

y \equiv \frac \ln \left(\frac}\right)

This differs slightly from the definition of rapidity in special relativity, which uses

\left|\mathbf\right|

instead of

p_\text

. However, pseudorapidity depends only on the polar angle of the particle's trajectory, and not on the energy of the particle. One speaks of the "forward" direction in a hadron collider experiment, which refers to regions of the detector that are close to the beam axis, at high

|\eta|

; in contexts where the distinction between "forward" and "backward" is relevant, the former refers to the positive ''z''-direction and the latter to the negative ''z''-direction.
In hadron collider physics, the rapidity (or pseudorapidity) is preferred over the polar angle

\theta

because, loosely speaking, particle production is constant as a function of rapidity, and because ''differences'' in rapidity are Lorentz invariant under boosts along the longitudinal axis: they transform additively, similar to velocities in Galilean relativity. A measurement of a rapidity difference

\Delta y

between particles (or

\Delta\eta

if the particles involved are massless) is hence not dependent on the longitudinal boost of the reference frame (such as the laboratory frame). This is an important feature for hadron collider physics, where the colliding partons carry different longitudinal momentum fractions ''x'', which means that the rest frames of the parton-parton collisions will have different longitudinal boosts.
The rapidity as a function of pseudorapidity is given by
:

y = \ln\left( \frac + p_\text \sinh \eta}}\right),

where

p_\text\equiv\sqrt+p_\text^}

is the transverse momentum (i.e. the component of the three-momentum perpendicular to the beam axis).
Using a second order Maclaurin expansion of

y

expressed in

m/p_\text

one can approximate rapidity by
:

y \approx \eta - \frac|} \left( \frac} \left( \frac} \left( \frac \gg m

, pseudorapidity becomes equal to (true) rapidity.
Rapidity is used to define a measure of angular separation between particles commonly used in particle physics

\Delta R \equiv \sqrt}

, which is Lorentz invariant under a boost along the longitudinal (beam) direction. Often, the rapidity term in this expression is replaced by pseudorapidity, yielding a definition with purely angular quantities:

\Delta R \equiv \sqrt}

, which is Lorentz invariant if the involved particles are massless. The difference in azimuthal angle,

\Delta\phi

, is invariant under Lorentz boosts along the beam line (''z''-axis) because it is measured in a plane (i.e. the "transverse" ''x-y'' plane) orthogonal to the beam line.
== Values ==

Here are some representative values:
:
Pseudorapidity is odd about

\theta = 90

degrees. In other words,

\eta(\theta)=-\eta(180^\circ-\theta)

.

抄文引用元・出典: フリー百科事典『ウィキペディア（Wikipedia）』
■ウィキペディアで「pseudorapidity」の詳細全文を読む

スポンサードリンク

翻訳と辞書 : 翻訳のためのインターネットリソース